Chapter 3 Basic Operations — Switching on/off the projector

Making adjustments and selections

It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.

2) 1) 5) 7) 8) 9)

6)

3)

2)

1) 8)

5)

3)

7) 9)

4)6)

1)Press the <FOCUS> button to roughly adjust the focus of the image. (x page 51)

2)Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] and [COOLING CONDITION] depending on the installation mode. (x page 35)

ff Refer to “Navigating through the menu” (x page 59) for the operation of the menu screen.

3)Press the input selection (<RGB1>, <RGB2>, <DVI-D>, <VIDEO>, <HDMI>, <SDI 1/2>) buttons to select the input signal.

4)Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 40)

5)Press the <SHIFT> button to adjust the position of the image.

6)If the input signal is an RGB signal, press the <AUTO SETUP> button.

7)Press the <ZOOM> button to adjust the size of the image to match the screen.

8)Press the <FOCUS> button again to adjust the focus.

9)Press the <ZOOM> button again to adjust the zoom and the size of the image to match the screen.

Note

ff When the projector is switched on for the first time after purchase, as well as when [ALL USER DATA] is executed from the [PROJECTOR SETUP] menu → [INITIALIZE], the focus adjustment screen is displayed after projection starts, then the [INITIAL SETTING] screen is displayed. Refer to “Start-up display” (x page 24) for details.

ENGLISH - 49