Chapter 4 Settings — [ADVANCED MENU] menu

15)Press as to select [UPPER], [LOWER], [LEFT], or [RIGHT] in [BLACK BORDER WIDTH].

16)Press qw to set the region (width) of the [BLACK BORDER WIDTH] adjustment.

17)Press as to select [UPPER KEYSTONE AREA], [LOWER KEYSTONE AREA], [LEFT KEYSTONE

AREA], or [RIGHT KEYSTONE AREA].

18)Press qw to adjust the tilt of the border between [NON-OVERLAPPED BLACK LEVEL] and [BLACK

BORDER LEVEL].

19)Press as to select [BLACK BORDER LEVEL].

20)Press the <ENTER> button.

ff The [BLACK BORDER LEVEL] screen is displayed.

ff If [INTERLOCKED] is set to [OFF], [RED], [GREEN], and [BLUE] can be adjusted individually.

21)Press as to select an item, and press qw to adjust the setting.

[BLACK BORDER WIDTH] (Right)

Projection range

Edge blending [WIDTH] (Right)

 

 

 

 

 

 

 

 

 

 

 

 

[MARKER] (Red)

Edge blending [START] (Right) ([MARKER] (Green))

[OVERLAPPED BLACK LEVEL] (Right)

[NON-OVERLAPPED BLACK LEVEL] [BLACK BORDER LEVEL]

Note

ff [BRIGHTNESS ADJUST] is a function that makes the increased brightness in black level of the overlapping image area difficult to notice when [EDGE BLENDING] is used to configure multiple screens. The optimal point of correction is set by adjusting [NON-OVERLAPPED BLACK LEVEL] so the black level of the overlapping image area will be the same level as the non-overlapping area. If the border area of the part where the image is overlapping and the non-overlapping part gets brighter after adjusting [NON-OVERLAPPED BLACK LEVEL], adjust the width of the top, bottom, left, or right. Adjust [BLACK BORDER LEVEL] when the width adjustment makes only the border area darker.

ff The joining part may look discontinuous depending on the position you are looking from when a screen with high gain or rear screen is used. ff When configuring multiple screens using both horizontal and vertical edge blending, adjust [OVERLAPPED BLACK LEVEL] first before

making adjustments in Step 12). Adjustment method is same as the procedure of [NON-OVERLAPPED BLACK LEVEL]. ff If only horizontal or vertical edge blending is used, set all items in [OVERLAPPED BLACK LEVEL] to 0.

ff [AUTO TESTPATTERN] settings change together with the [AUTO TESTPATTERN] of [COLOR MATCHING].

ff Adjustment of the tilt of the border between [NON-OVERLAPPED BLACK LEVEL] and [BLACK BORDER LEVEL] is a function to perform the adjustment of [GEOMETRY] (x page 74) together with the edge blending. If [NON-OVERLAPPED BLACK LEVEL] is tilted by correcting the keystone from [KEYSTONE] in [GEOMETRY], perform Steps 17) and 18) to adjust the edge blending according to the shape of [NON-OVERLAPPED BLACK LEVEL].

[FRAME RESPONSE]

Set image frame delay.

1)Press as to select [FRAME RESPONSE].

2)Press qw to switch the item.

ff The items will switch each time you press the button.

[NORMAL]

Standard setting.

[FAST]

Simplifies the image processing to reduce image frame delay.

Note

ff When [FRAME RESPONSE] is set to [FAST], picture quality deteriorates. Also, [DIGITAL CINEMA REALITY] cannot be set. ff [FRAME RESPONSE] cannot be set during P IN P.

[RASTER POSITION]

This will allow the position of the image to move within the display area arbitrarily when the input image is not using the whole display area.

1)Press as to select [RASTER POSITION].

80 - ENGLISH