Chapter 4 Settings — [POSITION] menu

When [ASPECT] is set to [DEFAULT]

1)Press as to select [ZOOM].

2)Press the <ENTER> button.

ff The [ZOOM] screen is displayed.

3)Press as to select [MODE].

4)Press qw to switch the item.

[INTERNAL]

Enlarges the size within the aspect range set with [SCREEN FORMAT].

[FULL]

Enlarges or reduces the size using the entire display area set with [SCREEN FORMAT].

5)Press as to select [INTERLOCKED].

6)Press qw to switch the item.

[OFF]

Sets the [VERTICAL] and [HORIZONTAL] zoom ratio.

[ON]

Uses [BOTH] to set zoom ratio. Image can be enlarged or reduced vertically and horizontally at the

same magnification.

 

7)Press as to select [VERTICAL] or [HORIZONTAL].

ff If [ON] is selected, select [BOTH].

8)Press qw to adjust.

Note

ff When [ASPECT] is not set to [DEFAULT], [MODE] is not displayed.

[CLOCK PHASE]

You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.

1)Press as to select [CLOCK PHASE].

2)Press qw or the <ENTER> button.

ff The [CLOCK PHASE] individual adjustment screen is displayed.

3)Press qw to adjust.

ff Adjustment value will change between [0] and [+31]. Adjust so that the amount of interference is at a minimum.

Note

ff Some signals may not be adjusted.

ff Optimal value may not be achieved if the output from the input computer is unstable. ff Optimal value may not be achieved when there is a shift in the total dot numbers.

ff [CLOCK PHASE] can be adjusted only when a signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal. ff [CLOCK PHASE] cannot be adjusted when a digital signal is input.

ff If you press w while the adjustment value is [+31], the value will become [0]. If you press q while the adjustment value is [0], the value will become [+31].

[GEOMETRY]

You can correct various types of distortion in a projected image.

Unique image processing technology enables projection of a square image on a special screen shape.

1)Press as to select [GEOMETRY].

2)Press qw to switch the item.

ff The items will switch each time you press the button.

[OFF]

Does not perform geometric adjustment.

[KEYSTONE]

Adjusts any trapezoidal distortion in the projected image.

[CORNER CORRECTION]

Adjusts any distortion in the four corners of the projected image.

[CURVED]

Adjusts any curved distortion in the projected image.

74 - ENGLISH