Chapter 2 Getting
Setting up
Installation mode
There are four ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 95) depending on the installation method. Set [COOLING CONDITION] to [AUTO]. Using the projector with [COOLING CONDITION] set incorrectly may shorten the life of the lamp.
Mounting on the ceiling and projecting forward | Setting on a desk/floor and projecting from rear |
| (Using the translucent screen) |
Menu item | Method | Menu item | Method |
[PROJECTION METHOD] | [FRONT/CEILING] | [PROJECTION METHOD] | [REAR/FLOOR] |
[COOLING CONDITION] | [AUTO] | [COOLING CONDITION] | [AUTO] |
|
| ||
Mounting on the ceiling and projecting from rear | Setting on a desk/floor and projecting forward | ||
(Using the translucent screen) |
|
|
|
Menu item | Method | Menu item | Method |
[PROJECTION METHOD] | [REAR/CEILING] | [PROJECTION METHOD] | [FRONT/FLOOR] |
[COOLING CONDITION] | [AUTO] | [COOLING CONDITION] | [AUTO] |
Parts for ceiling mount (optional)
You can install the projector on the ceiling using the optional Ceiling mount bracket (Model No.: ET‑PKD510H (for high ceilings), ET‑PKD510S (for low ceilings)).
ff Be sure to use the ceiling mount bracket specified for this projector.
ff Refer to the Installation Instructions of the ceiling mount bracket when installing and setting up the projector.
Attention
ff To ensure projector performance and security, installation of the Ceiling mount bracket must be carried out by your dealer or a qualified technician.
ENGLISH - 35