Panasonic PT-DZ16KD, PT-DZ16KE, PT-DZ16KU rrReceived data, rrError response, rrTransmitted data, When web control administrator rights password is not set (Non-protectmode)

Chapter 6 Appendix — Technical information

	Data section	Blank	Mode	Blank	Random number section	Termination
						symbol
Command	“NTCONTROL”	‘ ’	‘1’	‘ ’	“zzzzzzzz”	(CR)
example	(ASCII string)	0x20	0x31	0x20	(ASCII code hex number)	0x0d
Data length	9 bytes	1 byte	1 byte	1 byte	8 bytes	1 byte

ff Mode: 1 = Protect mode

3)Generate a 32-byte hash value from the following data using MD5 algorithm.

ff “xxxxxx:yyyyy:zzzzzzzz”

xxxxxxAdministrator rights user name for the web control (default user name is “admin1”)

yyyyyPassword of above administrator rights user (default password is “panasonic”)

zzzzzzzz8-byte random number obtained in Step 2)

Command transmission method

Transmit using the following command formats.

rrTransmitted data

	Header			Data section	Termination
					symbol
Command	Hash value	‘0’	‘0’	Control command	(CR)
example	(Refer to “Connecting” above)	0x30	0x30	(ASCII string)	0x0d
Data length	32 bytes	1 byte	1 byte	Undefined length	1 byte

rrReceived data

		Header		Data section	Termination
					symbol
Command	‘0’		‘0’	Control command	(CR)
example	0x30		0x30	(ASCII string)	0x0d
Data length	1 byte		1 byte	Undefined length	1 byte

rrError response

	String	Details
	“ERR1”	Undefined control command
	“ERR2”	Out of parameter range
Message	“ERR3”	Busy state or no-acceptable period
	“ERR4”	Timeout or no-acceptable period
	“ERR5”	Wrong data length
	“ERRA”	Password mismatch
Data length	4 bytes	―

Termination

symbol

(CR)

0x0d

1 byte

When web control administrator rights password is not set (Non-protect mode)

Connecting

1)Obtain the IP address and port number (Initial set value = 1024) of the projector and request for a

connection to the projector.

ff You can obtain both the IP address and the port number from the menu screen of the projector.

IP address	Obtain from the main menu → [NETWORK] → [NETWORK STATUS]
Port number	Obtain from the main menu → [NETWORK] → [NETWORK CONTROL] → [COMMAND PORT]

2)Check the response from the projector.

ENGLISH - 159