Chapter 1 Preparation — Start-up display

Initial setting (installation setting 1)

Set [PROJECTION METHOD] depending on the installation mode. Refer to “Installation mode” (x page 35) for details.

Set [HIGH ALTITUDE MODE] to [ON] when using the projector at high altitudes between 1 400 m (4 593') and 2 700 m (8 858') above sea level.

After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu.

1)Press as to select an item.

2)Press qw to switch the setting.

INITIAL SETTING

PROJECTION METHOD

FRONT/FLOOR

 

 

 

 

When PROJECTION METHOD is changed, confirm that

COOLING CONDITION is set correctly.

HIGH ALTITUDE MODE

OFF

 

 

 

 

Switch to HIGH ALTITUDE MODE "ON" if over 1400m (4593Ft).

MENU SELECT

CHANGE

ENTER SET

3)Press the <ENTER> button to proceed to the initial setting.

Initial setting (installation setting 2)

Set [COOLING CONDITION] depending on the installation mode. Refer to “Installation mode” (x page 35) for details.

After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [COOLING CONDITION].

1)Press qw to switch the setting.

INITIAL SETTING

COOLING CONDITION

AUTO

 

 

 

 

It may shorten the life of the lamp and projector if used in incorrect setting.

CHANGE

ENTER SET

2)Press the <ENTER> button to proceed to the initial setting.

ENGLISH - 25