Chapter 1 Preparation — Precautions for use

rrDo not install and use the projector in portrait setting.rrCautions when setting up the projector

ffWhen installing the projector at the section other than the floor by using the adjustable feet, use six screw holes for ceiling mount for fixing the projector (as shown in the figure).

(Screw diameter: M6, tapping depth inside the projector: 30 mm (1-3/16"), torque: 4 ± 0.5 N·m)

ffMake a clearance of at least 5 mm (3/16") between the projector bottom and the setting surface by inserting spacers (metallic) between them.

Adjustable feet

Mount

Spacer

Screw holes for ceiling mount (M6)

Adjustable feet

The positions of screw holes for ceiling mount and

adjustable feet

Clearance (5 mm (3/16") or longer)

Ensure the inflow of air into the air intake port. Otherwise the projector may not work properly.

ffThe adjustable feet can be removed if not needed in the installation. However, do not use the screw holes where the adjustable feet were removed to fix the projector in place.

Also, insert only the screws that are specified in the user manual of the optional accessories into the screw holes of the adjustable feet. Failure to do so may cause damage to the projector.

ffUse the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other purposes may damage the projector.

ffDo not stack projectors on top of each other.

ffDo not use the projector supporting it by the top.

ffDo not use the projector tilted at an angle that exceeds ±15° from the horizontal plane. ffDo not block the ventilation ports (intake and exhaust) of the projector.

ENGLISH - 19