Pioneer VSX-AX10Ai-G USB interface, Miscellaneous, Additional information, Symptom, Cause, Remedy

Additional information 12

USB interface

Symptom Cause Remedy

No sound. • The computer settings are incorrect.

•Make sure you have set up your computer system to output through the USB interface (see Using the USB interface on page 85).

•The software or source material you are using is not compatible with USB output.

•Update to a more recent version of your existing software, try a different audio program, or try a different source.

• The volume control on your computer is set • Turn up the volume on your computer. too low.

No sound from one or more channels.

• The software settings are incorrect, or the	• Try changing the software settings. If this doesn’t work,
program you are using cannot output	update to a more recent version of your existing software,
multichannel audio.	or try a different audio program.
• The wrong input setting is selected for the	• Change the setting accordingly (see Selecting USB and
USB interface.	multichannel analog input channels on page 47).

Miscellaneous

Symptom	Cause	Remedy
The receiver doesn’t seem to	• Static electricity caused by dry air.	• Switch the power off then on again. If this doesn’t seem
respond when the buttons are		to work, try disconnecting the power plug from the outlet,
pressed.		and insert again.
One of the Home THX 7.1	• There is only one surround back speaker	• Make sure there are two surround back speakers
channel modes is selected, but	connected or the current settings are for only	connected (see Connecting the speakers on page 24) and
there are certain options that	one surround back speaker.	make the necessary settings in Speaker Systems on
can't be chosen.		page 57.
There seems to be a time lag	• The subwoofer channel can be delayed	• See Automatically setting up for surround sound on
between the speakers and the	slightly if run through a low-pass filter.	page 37 to set up your system again using MCACC (this
output of the subwoofer.		will automatically compensate for a delay in the
		subwoofer output).

The receiver doesn’t memorize the last volume level you used before switching it off.

•The receiver was switched off immediately after changing the volume level.

•Make sure to switch off the receiver two seconds or more after changing the volume.

The receiver doesn’t memorize the last adjustments you made before switching it off.

•The receiver was switched off immediately after changing the receiver status.

•Make sure to switch off the receiver two seconds or more after changing the receiver status.

Note

•If the unit does not operate normally due to external effects such as static electricity, disconnect the power plug from the outlet and insert again to return to normal operating conditions.

105

En