Pioneer VSX-AX10Ai-G manual Getting started, Enter

04Getting started

4‘Auto Surround Setup’ should be highlighted. Press ENTER.

System Setup

[ Auto Surround Setup ]

[1. Input Assign]

[2. Surround Setup]

[3. Expert Setup]

[4. THX Audio Setup]

[Exit]

5Specify how you are using your speaker system. Highlight ‘Go Next’ then press ENTER.

If you are using a normal surround setup, or if you’re not sure, leave the settings at their default:

•Speaker System Select – Normal Surround

•SP-B(speaker system B) – Second Zone

•X-Curve – ON

For settings other than the default, see Speaker Systems on page 57.

Auto Surround Setup

Speaker System Select

[ Normal Surround ]

SP–B	[Second Zone]
X–Curve	[ ON ]
[Go Next]
[Return]

6 Follow the instructions on-screen.

Auto Surround Setup

•Connect microphone

•Please be quiet

•Move obstacles away

•If you have a subwoofer turn power on and

turn volume up

[Start] [Cancel]

•Make sure the microphone is connected.

•If you’re using a subwoofer, switch it on and turn up the volume.

•See below for notes regarding high background noise levels and other possible interference.

7Make sure ‘Start’ is selected, then press ENTER. A progress report is displayed on-screen while the receiver outputs test tones to determine the speakers present in your setup. Try to be as quiet as possible while it’s doing this.

Auto Surround	Setup	Auto Surround Setup
			Now Analyzing•••
		Environment Check
Please Wait		Ambient Noise			[OK]
		Microphone			[OK]
Caution!!		Speaker Level			[OK]
Test tone is		[		]
output	loudly.		Cancel

[Cancel]

38

•Do not to turn down the volume during the test tones. This may result in incorrect speaker settings.

8Confirm the speaker configuration in the OSD. The configuration shown on-screen should reflect the actual speakers you have.

	Check!!
	FRONT			[ YES	]
	CENTER			[ YES	]
	SURROUND			[ YES	]
	SURR BACK			[ YESX2]
	SUB WOOFER [ YES				]
[			]
	OK,Go Next
	[Retry]
[ERR Fix		SP.]
[Return to		Menu]

If the speaker configuration displayed isn’t correct, use

the (cursor up/down) buttons to select Retry, then press ENTER. Follow the instructions from step 6.

If the configuration is incorrect and you want to input the settings manually, select ERR Fix SP then press

ENTER. Use		(cursor up/down) to select the speaker
then	(cursor left/right) to specify the size (and

number for surround back). When you’re finished, go to the next step.

If you see an ERR message in the right side column, there may be a problem with the speaker connection. If selecting Retry (above) doesn’t fix the problem, turn off the power and check the speaker connections.

9Make sure ‘OK, Go Next’ is selected, then press

ENTER.

A progress report is displayed on-screen while the receiver outputs more test tones to determine the optimum receiver settings for channel level, speaker distance, and acoustic calibration EQ.

Auto Surround			Setup	Auto Surround Setup
					Now Analyzing•••
				Surround
	Please Wait						Analysis
				Speaker			Systems	[OK]
Caution!!				Speaker Distance				[OK]
				Channel			Level	[OK]
	Test tone is			Acoustic Cal EQ				[OK]
	output		loudly.
[	Cancel	]		[	Cancel	]

Again, try to be as quiet as possible while this is happening. It may take up to 6 minutes.

En