Pioneer VSX-AX10Ai-G manual Using other functions, Reducing the level of an analog signal

Using other functions

Reducing the level of an analog signal

The input attenuator lowers the input level of an analog signal when it’s too strong. You can use this if you find the that the OVER indicator is lights often, or you can hear distortion in the sound.

•From the remote control receiver menu, press INPUT ATT to switch the input attenuator on or off.

You may need to press RECEIVER on the Home menu () first before reaching the receiver menu screen shown

below (use the (cursor left/right) soft keys to go to the previous/next menu screen).

RECEIVER 3/3

TV

RECEIVER CONT

INPUT	SB CH
	MODE
SPEAKER	INPUT
A/B	ATT
VIDEO	DISPLAY
SELECT	DIMMER
TAPE2	STATUS
MONITOR

09

Adjusting the delay of a soundtrack

Some monitors have a slight delay when showing video, so the soundtrack will be slightly out of sync with the picture. By adding a bit of delay, you can adjust the sound to match the presentation of the video.

1Press OPTION repeatedly until SOUND DELAY shows in the display.

With the remote, you may need to press RECEIVER on the

Home menu () first before reaching the receiver menu

screen shown below (use the (cursor left/right) soft keys to go to the previous/next menu screen).

RECEIVER 2/3

TV

RECEIVER CONT

MIDNIGHT		DIGITAL NR
	TONE	LOUDNESS
–	OPTION		+
–	CH LEVEL		+

ACOUSTIC										TUNER	SBCH
CAL.	MIDNIGHT	LOUDNESS	TONE	OPTION			DIGITALNR	INPUT ATT	CLASS	STATION	MODE
PHONES	SPSYSTEM	SIGNAL	VIDEO	TAPE2	STREAM	SETUP			VIDEOINPUT
	A/B	SELECT	SELECT	MONITOR	DIRECT	MIC	DIGITALIN
									S-VIDEO	VIDEO	L AUDIO R

Note

•The attenuator isn’t available with digital sources, or when using Stream Direct modes 2 or 3.

ACOUSTIC										TUNER	SBCH
CAL.	MIDNIGHT	LOUDNESS	TONE	OPTION			DIGITALNR	INPUT ATT	CLASS	STATION	MODE
PHONES	SPSYSTEM	SIGNAL	VIDEO	TAPE2	STREAM	SETUP			VIDEOINPUT
	A/B	SELECT	SELECT	MONITOR	DIRECT	MIC	DIGITALIN
									S-VIDEO	VIDEO	L AUDIO R

2Use the (OPTION) +/– buttons to adjust the amount of delay.

The delay can be adjusted from 0.0–6.0 frames (in 0.1 frame steps).

3Press ENTER to confirm.

Note

•When listening to an analog source, you can’t use sound delay when Stream Direct is on.

•One second is equal to 30 frames of NTSC format video, and 25 frames of PAL.

75

En