Plugging in the receiver, PAL model, NTSC model

Connecting your equipment

To improve AM reception, connect a 5–6 meter length of vinyl-coated wire to the AM LOOP terminals without disconnecting the supplied AM loop antenna.

For the best possible reception, suspend horizontally outdoors.

Check the table below for the correct AC cord (and converter, if necessary) for your region.

PAL model

Region

Plug type

Outdoor antenna

ANTENNA

5–6 m

AM LOOP

ANTENNA

75Ω UNBAL

Indoor antenna

(vinyl-coated wire)

UK type region

UK three pin plug

European type region

Plugging in the receiver

Only plug in after you have connected all your components to this receiver, including the speakers.

Caution

•Handle the power cord by the plug part. Do not pull out the plug by tugging the cord, and never touch the power cord when your hands are wet, as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, or other object on the power cord or pinch the cord in any other way. Never make a knot in the cord or tie it with other cables. The power cords should be routed so that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electric shock. Check the power cord once in a while. If you find it damaged, contact the Pioneer Service Center specified on your warranty card for a replacement.

•Do not use any power cord other than the one supplied with this unit.

•Do not use the supplied power cord for any purpose other than that described below.

•The receiver should be disconnected by removing the mains plug from the wall socket when not in regular use, eg., when on vacation.

1Plug the supplied power cord into the AC IN socket on the back of the receiver.

2Plug the other end into a power outlet.

About the supplied AC power cords

This model has two power cords and plug converters.The type of cord and the plug converter which can be used depends on the power voltage in each region or country. Please make sure you use the correct cord and plug converter due to the possibility of fire or other hazard if used incorrectly.

European two pin plug

For regions with two pin flat- bladed plug and 200 volts or greater power supply

AC power cord (main unit)

AC adapter cord (recharger)

European two pin plug with two pin flat-bladed converter plug (for 200 volts or greater power supply)

NTSC model