08Controlling other equipment
To exit without saving the preset you have assigned, press CANCEL instead of INSTALL above.
Tip
• Pioneer DVD recorders fall into the following setting |
types: |
|
• Use the (cursor up/down) buttons to scroll through the component options (the RECEIVER and TUNER screens are not available).
3On the touch screen, press the button that corresponds to the command you want to teach the remote control.
For example, choose the (play) button to program this remote control to start playback on your DVD player.
If you have more than one Pioneer DVD recorder of |
setting type |
for each (allowing for separate control). |
Programming signals from other remote controls
If the preset code for your component is not available, or the available preset codes do not operate correctly, you can program signals from the remote control of another component. This can also be used to program additional
LEARN
END
DVD1/2
DVD | TV |
| CONT |
AUDIO | SUBTITLE |
DISPLAY | TOP MENU |
LEARN
END
DVD2/2
DVD | TV |
| CONT |
1 2 3 CLR
4 5 6 +10
7 8 9 0
SEARCH RETURN MODE
operations (buttons not covered in the presets) after assigning a preset code in Recalling preset codes on page 66.
1 Press LEARNING on the remote setup menu.
SETUP 1/3
CALIBRATE
PRESET RECALL
LEARNING
MULTI OPERATION
DIRECT FUNCTION
2From the ‘Select Function’ screen, choose the input function which matches the connection for the component you want to control.
For example, press DVD/LD if you want to program signals for the DVD player that you connected to the DVD/LD terminals.
A remote icon shows in the top right corner of the touch screen after you’ve selected a button (you can deselect it by pressing it again).
•Remote control soft keys such as 
, 
, (cursor left/right) and TV CONT are used to select menu screens (even in learning mode), so therefore cannot be programmed.
• The Learn and L buttons that appear on some component screens are unassigned buttons which can be used to learn new commands. See Editing remote control button names on page 69 to change the name once you’ve programmed a command.
•You can program the remote control hard keys
(VOLUME +/– and MUTE are only available with TV CONTROL), but the command will remain the same for all screens of the component selected.
•Press END to go back without making any changes.
4While the icon is displayed, point the two remote controls toward each other and press the button on the other remote control corresponding to the operation you want to program.
Select Function
LEARNING
DVD/LD
TV/DVD
SAT
CANCEL
| 3 | 6 | 9 |
|
- | - |
|
|
|
| 2 | 5 | 8 | 0 |
1 | 4 | 7 |
- | - |
12 – 30 cm
When the command has been learned, OK! shows on the remote control touch screen and the remote control returns to the command learning screen (step 3). Repeat steps 3 and 4 to program additional commands.
If you want to learn signals for additional components, press END to go back to the Select Function screen and start again from step 2.
68
En
