Pioneer VSX-AX10Ai-G Switching components on and off, using the 12 volt trigger, Using System off

Controlling other equipment 08

Using System off

•From the remote control Home menu press

SYSTEM OFF.

The command sequence you programmed will run, then all Pioneer components will switch off, followed by this receiver.

2Connect the CONTROL OUT jack of that component to the CONTROL IN jack of another Pioneer component.

Use a cable with a mono mini-plug on each end for the connection.

HOME 1/3

RECEIVER		RECEIVER
INPUT 1	2	3

	CONTROL		CONTROL
IN	OUT	IN	OUT

DVD	TV	SAT
/ LD	/ DVD
DVR	CD	TUNER
/ VCR1									VSX-AX10Ai
TV	MULTI	SYSTEM
CONT	OPERATION	OFF				CONTROL
							MONITOR
	SETUP						OUT 1
			0	(AUDIO)						AN
					OUT	IN	MONITOR
							OUT 2
						DVD/		COMPONENT VIDEO
							IN	(DVD/		AM LO
						LD		LD)	Y	ANTEN
						IN		IN
			AUDIO	POWER		TV/		1 Y	MONITOR
Switching components on and off				AMP			IN		OUT	FM
				IN		DVD			PB
							IN			75Ω U
						IN			PR
						IN		PB
						SAT
using the 12 volt trigger			3 Continue the chain in the same way for as many
You can connect components in your system (such as a
			components as you have.
screen or projector) to this receiver so that they switch on
or off using a 12 volt trigger when you select an input			Note
function. However, you must specify which input
functions switch on which trigger(s) using the Expert			• If you want to control all your components using this
Setup menu (see 12 Volt Trigger on page 93 to do this).
			receiver’s remote control, refer to Using the remote
Note that this will only work with components that have a
			control with other components on page 66 and
standby mode.
			Programming signals from other remote controls on
• Connect the 12V TRIGGER jack of this receiver to			page 68.
the 12V TRIGGER of another component.
Two connections are possible. Use a cable with a mono
mini-plug on each end for each connection.

After you’ve specified the input functions that will switch on the trigger(s), you’ll be able to switch the component on or off just by pressing the input function(s) you’ve set on page 93.

Operating other Pioneer components with this unit’s sensor

Many Pioneer components have SR CONTROL jacks which can be used to link components together so that you can use just the remote sensor of one component. When you use a remote control, the control signal is passed along the chain to the appropriate component.

Note that if you use this feature, make sure that you also have at least one set of analog audio jacks connected to another component for grounding purposes.

1Decide which component you want to use the remote sensor of.

When you want to control any component in the chain, this is the remote sensor at which you’ll point the corresponding remote control.

73

En