Polling Transmission

E Press [Only Once] or [Save] to delete or save the file after transmission.

Note

❒To delete the original immedi- ately after transmission, select

[Only Once].

❒To repeatedly send the original, select [Save].

❒To cancel Polling Transmission, press [Cancel]. The display re- turns to that of step C.

F Press [OK].

“pppppppppp” ap- pears.

The type of Polling Transmission is shown above the highlighted [Polling TX].

G Press [OK].

Note

❒To check the settings, press

[Transmission Mode].

H Press the {Start} key.

Note

❒You can cancel the transmission setup for Polling Transmission. See p.19 “Canceling a Transmis- sion”.

Polling Transmission Clear

Report

This report allows you to verify Poll-

1

ing Transmission has taken place.

 

If E-mail TX Results is programmed in a Quick Operation key, you can have the report e-mail sent after transmission. See p.146 “Quick Operation Key”.

Limitation

❒This report is not printed if the User Parameters are set to allow the stored originals to be repeated- ly sent (Save). See p.166 “User Pa- rameters” (switch 11, bit 7).

Note

❒You can turn this function on or off with the User Parameters. See p.166 “User Parameters” (switch 03, bit 6).

❒You can have a portion of the sent image printed on the report with the User Parameters. See p.166 “User Parameters” (switch 04, bit 7).

❒You can check the result of Polling Transmission with the Journal. See p.27 “Printing the Journal”

❒To view the report without text disruption, select a font of even character width in your e-mail ap- plication's settings.

❒You can display a destination with the User Parameters. See p.166 “User Parameters” (switch 04, bit 4).

❒You can indicate the receiving par- ty's information with the User Pa- rameters . See p . 166 “ User Parameters” (switch 04, bit 5).

13