Ricoh Facsimile Stamp, Note, Note, [OK], Press, Start, [Stamp], [Stamp], Reference, B Press [Sub TX Mode], C Press [Stamp], and then press [OK]

Other Transmission Features

Stamp

	The optional ADF is required.
	When sending a fax message using
	the ADF, the machine can stamp a cir-
	cle mark at the bottom of the original.
	When sending a two-sided docu-
	ment, the document is marked at the
	bottom of the front page and top of
	the rear page. This stamp indicates
	that the original has been successfully
	stored in memory for Memory Trans-
	mission, or successfully sent by Im-
4
	mediate Transmission.

Note

❒Stamp only works when scanning from the ADF.

❒When the stamp starts getting lighter, replace the cartridge. See “Replacing the Stamp Cartridge”, General Settings Guide.

❒If a page was not stamped even though the Stamp function is turned on, you need to resend that page.

❒If you use this function often, you can set the default in General Set- tings and Adjustment so that this function is always on. In this case, Stamp can easily be turned off for any single transmission by press- ing [Stamp]. See p.144 “General Set- tings/Adjustment”.

❒A paper jam during Parallel Mem- ory Transmission may cause the transmission to be failed even if stamping is performed.

❒You cannot turn the Stamp func- tion on or off while a document is being scanned.

A Place the original, and then select the scan settings you require.

Reference

p.13 “Placing Originals”, Facsimile Reference <Basic Features>

p.30 “Scan Settings”, Facsimile

Reference <Basic Features>

B Press [Sub TX Mode].

C Press [Stamp], and then press [OK].

Note

❒To cancel the stamp, press [Stamp] again before pressing [OK].

D Specify the destination, and then press the {Start} key.

72