1 Press the power switch on the rear of the library.
The messages on the right appears and the startup process begins. (Startup takes several minutes.)
Initializing
When the startup process ends, the library enters the time setting mode.
Caution
Models equipped with a bar code reader
By default, the library is not set to read bar codes. If you modify this setting so that the library can read bar codes and use cartridges without bar code labels, initialization after turning on the library takes unusually long. For details about how to set the library to read bar codes, see Chapter 3, “Basic Usage” (page 34).
Models without a bar code reader Modifying the default setting so that the library can read bar codes generates an error. You should not modify this setting.
Jan/01/2001 12:00:00 [ENTER] to set the
Date and Time
[CANCEL] to exit
2 If you want to change the date and time, press the [ENTER] button. If you do not want to make changes, press the [CANCEL] button.
For details about the date and time settings, see “Setting the Date and Time” (page 22).
Once the library is started, the status | READY | 1 | 2 | 3 | 4 | |||||
display on the right appears. |
|
|
| |||||||
|
|
|
|
|
|
|
|
|
| |
|
| AIT3 |
|
|
|
| 5 | 6 | 7 | 8 |
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
Chapter 2 Installation | 20 |
|
|