8 If you selected “1. Single Mode” in step 4, press the [CANCEL] button.
Note
Slot 01 Insert Tape [CANCEL] to exit
Even if you selected “1. Single Mode” in step 4, you can insert a different cartridge by using the V and v buttons to select the slot element address, and then pressing the [ENTER] button. Because you did not select “2. Multiple Mode” in step 4, the cartridge dock shutter closes and reopens. When it does, you can insert another cartridge as explained above. If you do so, when you are done inserting cartridges press the [CANCEL] button and proceed to step 10.
9 If you selected “2. Multiple Mode” in step 4, perform the following depending on the number of open slots.
Two or more open slots
The slot moves to the next one. When it stops, insert another cartridge and press the [ENTER] button again. Repeat until all the cartridges are inserted, then press the [CANCEL] button.
1 Insert a cartridge and press the [ENTER] button.
2 The slot moves to the next. Insert another cartridge in the same manner and press the [ENTER] button.
When you press the [ENTER] button, the slot moves to the next.
3 Repeat until all the cartridges are inserted, and then press the [CANCEL] button.
Insert Tape Slot 01
Next Slot 02
[CANCEL] to exit
[ENTER] to next slot
Only one open slot
The element address of the front slot appears on the first line. (Nothing appears on the second line.)
1 Insert a cartridge and press the [CANCEL] button.
Caution
Insert Tape Slot 01
[CANCEL] to exit
Do not put your fingers in the slot when it is moving, as this could result in injuries.
Chapter 2 Installation | 28 |
|
|