At the status display, press the [MENU] button for two seconds.

2 Check whether the erase-protection tab is set to the write-enable position.

If the tab is orange, data can be written to the cartridge.

AIT-1

AIT-5, AIT-4, AIT-3 Ex, AIT-3, AIT-2 Turbo,

 

AIT-2, AIT-1 Turbo, AIT-E Turbo

Lid

Lid

If the tab is moved to the left, data can be written to and erased from the cartridge.K

If the tab is moved to the right, data cannot be written or accidentally erased from the cartridge.k

If the tab is lowered, data can be written to and erased from the cartridge.j

If the tab is raised, data cannot be written to or accidentally erased from the cartridge.J

Setting the Cartridge

Set the cartridge into the AIT library. When setting the cartridge, specify the slot by its element address. For information about element addresses, refer to “Assigned Element Addresses” (page 48) in Chapter 3, “Basic Usage”.

1

2 Use the V and v buttons to select “2.Eject/Insert”, then press the [ENTER] button.

“Eject/Insert” appears.

3 Select “3.Insert Into Library”, then press the [ENTER] button.

Eject/Insert 12:34 1.Eject From Library 2.Eject From Drive 3.Insert Into Library

4 Select the cartridge insertion

 

 

Insert

12:34

method, then press the [ENTER]

1.Single

Mode

button.

2.Multiple Mode

•When you want to specify a slot and insert the cartridge in it, select “1. Single Mode”.

•When you want to insert several cartridges consecutively, select “2. Multiple Mode”. In this case, you only need to specify the first slot.

5 Use the V and v buttons to set the Slot 01 element address of the slot where

the cartridge is going to be set, then press the [ENTER] button.

Chapter 2 Installation

26