Operating the

AIT Library Chapter

Overview

This chapter explains how to take out, change and move the cartridges, how to view information about the AIT library, cartridges and errors, and how to test the hardware.

Using the Cartridges

This section explains steps to take out, change and move the cartridges.

For information about how to prepare and load the cartridges, refer to “Setting the Cartridges” (page 25) in Chapter 2, “Installation”.

Taking Out the Cartridges

To take out a cartridge set in the AIT library or AIT drives specify the slot with the element address.

For information about element addresses, refer to “Assigned Element Addresses” (page 48) in Chapter 3, “Basic Usage”.

To take a cartridge out of the AIT library:

1 At the status display, press the [MENU] button for two seconds.

2 Use the V and v buttons to select “2.Eject/Insert”, then press the [ENTER] button.

“Eject/Insert” appears.

3 Select “1.Eject From Library”, then press the [ENTER] button.

Eject/Insert 12:34 1.Eject From Library 2.Eject From Drive 3.Insert Into Library

Chapter 4 Operating the AIT Library

50