19 Select “2. Shutdown”, then press the [ENTER] button.
20 When “[ENTER] to activate” appears, press the [ENTER] button.
The system performs the shutdown procedure
21 When the message on the right appears, turn off the library by pressing the power switch on the rear.
System Down | 12:34 |
1.Reset
2.Shutdown
Shutdown
[ENTER] to activate
Shutdown
*** Wait a minute ***
Ready for shutdown Press the power switch on the rear of the Library
When the network settings are done and the library turned off, connect the network cable.
1 Connect a network cable from the hub to the Ethernet connector on the library.
2 Turn on the library power.
Accessing the AIT Library From a BrowserUse a browser to check whether the library is connected to the network.
1 Launch a browser on a client computer.
2 Enter “http://XXX.XXX.XXX.XXX/” in the “Address” or “Location” field.
For “XXX.XXX.XXX.XXX”, enter the IP address set in the library. (e.g., 192.168.0.1)
Note
If the IP address assigned by a DHCP server is being used, enter the current IP address in the “Address” field of the browser. The current IP address can be checked with [IP Address] of the Network Menu of the control panel.
The top page of the Library Administration Menu appears.
Chapter 2 Installation | 32 |
|
|