Basic Settings
This section explains the steps required to configure the warning message display, bar code,
Caution
There exist
Note
For information about “Date & Time” of the Configuration Menu, refer to “Setting the Date and Time” (page 22) in Chapter 2, “Installation”.
Disabling the Life Warning Display
When the device is shipped from the factory, the life warning is set to display.
This default setting is recommended. (Thus the following setup is unnecessary.)
Change this setting in “Warning” of the Configuration Menu.
Note
The displaying of the life warning can also be set through a browser.
1
2 Use the V and v buttons to select “5.Configuration”, then press the [ENTER] button.
3
4
Select “2.Warning”, then press the |
|
|
| |
Configuration | 12:34 | |||
[ENTER] button. | ||||
1.Date | & Time |
| ||
| 2.Warning |
| ||
| 3.Barcode |
| ||
Use the V and v buttons to select |
|
|
| |
Warning |
|
| ||
“YES”, then press the [ENTER] |
|
| ||
Enable | YES |
| ||
button. |
|
|
|
The default factory setting is “YES”.
Select “NO” to not display the warning.
5 When “[ENTER] to activate” appears, press the [ENTER] button.
The life warning is now set. The display returns to the menu.
Warning
Enable YES
[ENTER] to activate
6 Press the [CANCEL] button twice to return to the status display.
Chapter 3 Basic Usage 43