About SCSI parity
When the SCSI parity function is enabled, parity checks are performed on all data passing through the SCSI bus. The factory default settings for SCSI parity are as follows:
• | Library: | Enabled (YES) |
• | AIT Drive: | Enabled (YES) |
Caution
Do not duplicate SCSI IDs.
Note
The SCSI IDs can also be set through a browser.
1
2 Use the V and v buttons to select “4.SCSI”, then press the [ENTER] button.
3 Set the SCSI ID and SCSI parity of |
|
|
|
| ID | Parity | |
the library. | Library | 01 | YES |
| Drive | 02 | NO |
|
|
|
|
4
5
1 When the “ID” of “Library” setting flashes, use the V and v buttons to set the SCSI ID, then press the [ENTER] button.
2When the “Parity” setting flashes, use the V and v buttons to set the SCSI parity, then press the [ENTER] button.
Select “YES” to enable the SCSI parity function.
In the same manner, set the AIT Drive. |
|
| |
When “[ENTER] to activate” |
|
|
|
| ID | Parity | |
appears, press the [ENTER] button. |
| ||
Library | 01 | YES | |
| Drive | 02 | NO |
| [ENTER] to activate | ||
6 When “[Enter] to reset” appears, press the [ENTER] button.
The system reboots.
Warning 12:34 Reboot the system to activate the setting
[ENTER] to reset
Caution
If you change the SCSI ID while the library is connected to the host computer, you must also restart the host computer.
Chapter 2 Installation | 24 |
|
|