Notes

•After connecting to the network, a browser can be used to change network settings.

•The AIT library does not support DNS. (You do not need to set the [Host], [Domain], or [DNS] settings in the procedure below.)

•You can obtain the AIT library’s MAC address from the Network Menu.

1

2

3

At the status display, press the [MENU] button for two seconds.

Use the V and v buttons to select

 

 

Menu

12:34

“6.Network”, then press the

4.SCSI

 

[ENTER] button.

5.Configuration

 

“Network” appears.

6.Network

 

 

 

When you want to set the host

 

 

Network

12:34

name, select “1.Host”, then press

1.Host

 

the [ENTER] button. (However, the

2.Domain

 

AIT library does not support DNS,

3.IP Address

 

therefore this setting is

 

 

unnecessary.)

 

 

4 When the “Host” setting flashes, set the host name. (However, the AIT library does not support DNS, therefore this setting is unnecessary.)

Host

■

If no setting has been made, a flashing rectangle appears.

•In order to change the host name, use the V button, the v button, the [ENTER] button and the [CANCEL] button to enter the new host name, then press the [ENTER] button. First, make sure that the same host name does not exist in the same network, then enter the host name.

-Enter the host name up to 63 alphanumeric characters and symbols ( -

. ).

-To delete a character, use space (“ ”).

5 When [[ENTER] to activate]

 

Host

appears, press the [ENTER] button.

LIB-81

The display returns to “Network”.

[ENTER] to activate

 

6 When you want to set the domain name, select “2.Domain”, then press the [ENTER] button. (However, the AIT library does not support DNS, therefore this setting is unnecessary.)

7 When the “Domain” setting flashes, set the domain name.

If no setting has been made, a flashing rectangle appears.

•In order to change the domain name, use the V button, the v button, the [ENTER] button and the [CANCEL] button to enter the new domain name, then press the [ENTER] button.

-Enter the domain name up to 63 alphanumeric characters and symbols ( - . ).

-To delete a character, use space (“ ”).

Chapter 2 Installation

30