2 In the “Current Password” box, enter the current password.

If you are setting the password for the first time, enter “LIB-81A”.

3 In the “New Password” box, enter the new password up to eight alphanumeric characters and symbols (! @ # $ % ( ) - { } ~ ").

4

5

In the next “Confirm New Password” box, re-enter the same password.

Click “Submit”.

A message that indicates the completion of setting is displayed.

Caution

The maximum number of characters that can be set for the password is eight. It is not possible to input more than eight characters.

Maintenance Menu

In the Maintenance Menu, the condition of the AIT library can be checked, and the firmware of this library can be updated.

Note

Each access to the Maintenance Menu requires the password to be entered. Enter “LIB-81A” in the “Password” box, then click “OK”. For information about the password, refer to “Password” (page 75).

The following items are in the Maintenance Menu.

•Life Count

Displays the number of times a specific part has been operated.

•Error Count

Displays the number of times an operation was tried or an error occurred in a specific part.

•Sensor

Displays information about the individual sensors, DIP switches and encoder values.

•History

Logs can be viewed.

•Diagnostic

You can check whether or not the AIT library is functioning normally.

•Firmware Upload

The firmware of the AIT library can be uploaded.

Chapter 6 Using the Library Administration Menu 76