Notes
•The date and time cannot be updated when the AIT library is off. For this reason we recommend that you set the date and time each time you turn on the library.
•If the library is left idle for five minutes, the status display appears automatically.
3 After pressing the standby switch on the library's front panel, wait at least 10 seconds before turning on the host computer.
When using DHCP, wait at least 30 seconds.
Then, go to “Initial Setup” (page 22).
Notes
•If you start the host computer before the library, the SCSI ID is not detected correctly. Therefore, always start the library before starting the host computer.
•If the library does not work as above, refer to “Troubleshooting” (page 92).
Turn the Power OffBefore turning off the library, perform the system shutdown procedure from the control panel. After you have performed the procedure, you can turn off the library.
1
2
At the status display, press the [MENU] button for two seconds.
Use the V and v buttons to select |
|
| |
Menu | 12:34 | ||
“9. System Down,” then press the | |||
7.Tape Inventory |
| ||
[ENTER] button. | 8.Password |
| |
| 9.System Down |
|
3 Select “2. Shutdown,” then press the [ENTER] button.
System Down | 12:34 |
1.Reset
2.Shutdown
4
5
When “[ENTER] to activate” appears, press the [ENTER] button.
The system performs the shutdown procedure.
When the message on the right appears, turn off the library by pressing the power switch on the rear.
Shutdown
[ENTER] to activate
Shutdown
*** Wait a minute ***
Ready for shutdown Press the power switch on the rear of the Library
Caution
•Even though pressing the rear power switch can turn off the library power, following the above steps is recommended.
Chapter 2 Installation | 21 |
|
|