Cleaning the AIT Drive
When the AIT drive needs to be cleaned, the following message appears on the
LCD panel:
Warning 12:34
Cleaning request
Clean the drive by setting the Cleaning cartridge (sold separately) in the AIT drive. To set the cleaning cartridge, specify the slot and the AIT drive with an element address. For information about element addresses, refer to “Assigned Element Addresses” (page 48) in Chapter 3, “Basic Usage”.
There are four types of cleaning cartridges: the
Note
First set the cleaning cartridge in the AIT library, then move it to the AIT drive. Check in advance which slot is not occupied. For information about how to check, refer to “Viewing Cartridge Information” (page 60) in Chapter 4, “Operating the AIT Library”.
1
2 Use the V and v buttons to select “2.Eject/Insert”, then press the [ENTER] button.
3
4
5
“Eject/Insert” appears. |
|
|
|
Select “3.Insert Into Library”, then |
|
| |
Eject/Insert | 12:34 | ||
press the [ENTER] button. | 1.Eject From Library | ||
| 2.Eject From Drive | ||
| 3.Insert Into Library | ||
Select “1. Single Mode”, then press |
|
|
|
Insert |
| 12:34 | |
the [ENTER] button. | 1.Single | Mode |
|
| 2.Multiple Mode |
| |
Use the V and v buttons to set the |
|
|
|
|
|
| |
Slot 01 |
|
| |
element address of the slot where |
|
| |
|
|
| |
the cleaning cartridge is going to be |
|
|
|
set, then press the [ENTER] button. |
|
|
|
6 When “[ENTER] to activate” |
|
|
Slot 01 |
| |
appears, press the [ENTER] button. |
|
|
| [ENTER] | to activate |
Chapter 5 Operating the AIT Drive | 63 |
|
|