Only one inserted cartridge
The element address of the front slot appears on the first line. (Nothing appears on the second line.)
1 Eject the cartridge and press the [CANCEL] button.
Eject Tape Slot 01
[CANCEL] to exit
Caution
Do not put your fingers in the slot when it is moving, as this could result in injuries.
10 When “[ENTER] to activate” appears, press the [ENTER] button.
If you selected “1. Single Mode” in step 4, the display on the right appears.
Slot 01
Exit ?
[ENTER] to activate
If you selected “2. Multiple Mode” in step 4, the display on the right appears.
Eject Tape Slot 01 Exit ?
[ENTER] to activate
The shutter closes and the |
| ||
Slot 01 | |||
initialization is performed. | |||
| |||
|
| Initializing | |
|
| ||
Caution |
|
| |
Keep your fingers clear of the |
| ||
shutter when it closes. |
| ||
11 When the initialization ends, press the [CANCEL] button to return to “Eject/Insert” display.
12 Select “3.Insert Into Library”, then press the [ENTER] button.
Eject/Insert 12:34 1.Eject From Library 2.Eject From Drive 3.Insert Into Library
13 Select the cartridge insertion |
|
|
Insert | 12:34 | |
method, then press the [ENTER] | 1.Single | Mode |
button. | 2.Multiple Mode | |
•When you want to specify a slot and insert cartridge in it, select “1. Single Mode”.
•When you want to insert several cartridges consecutively, select “2. Multiple Mode”. In this case, you only need to specify the first slot.
14 Use the V and v buttons to set the Slot 01 element address of the slot where
the cartridge is going to be set, then press the [ENTER] button.
Chapter 4 Operating the AIT Library | 56 |
|
|