10 When “[ENTER] to activate” appears, press the [ENTER] button.
If you selected “1. Single Mode” in step 4, the display on the right appears.
Slot 01
Exit ?
[ENTER] to activate
If you selected “2. Multiple Mode” in step 4, the display on the right appears.
Insert Tape Slot 01 Exit ?
[ENTER] to activate
The shutter closes and the | Slot 01 | |
initialization is performed. | ||
| ||
| Initializing | |
|
|
11 When the initialization ends, press the [CANCEL] button three times to return to the status display.
Connecting to the Network
If the AIT library is connected to the network, a browser can be used to configure the library and view status information.
Connect the AIT library to the network as follows.
1
2
3
4
Setup the network.
Connect a network cable.
Restart the library.
Access the library from a browser.
Notes
•For information about how to use the browser to configure individual settings and view status information, refer to Chapter 6, “Library Administration Menu” (page 67).
•In order to configure and maintain the library through a browser, browser software must be installed in the computer. The following operating systems and browsers are compatible with the library.
Operating systems:
-Microsoft Windows 95, Microsoft Windows 98, Microsoft Windows Me, and Microsoft Windows 2000
Browsers:
-Microsoft Internet Explorer 5.01 or later
-Netscape Communicator 4.7 or later
Setting the Network
In order to connect to the network, use the Network Menu of the control panel to configure the necessary settings, such as the IP address setting.
Chapter 2 Installation | 29 |
|
|