7 Remove the cartridge from the slot.
Raise the cartridge about 1 mm and pull it out.
8 If you selected “1. Single Mode” in step 4, press the [CANCEL] button.
Note
Slot 01 Eject Tape [CANCEL] to exit
Even if you selected “1. Single Mode” in step 4, you can remove a different cartridge by using the V and v buttons to select the slot element address, and then pressing the [ENTER] button. Because you did not select “2. Multiple Mode” in step 4, the cartridge dock shutter closes and reopens. When it does, you can remove another cartridge as explained above. If you do so, when you are done removing cartridges press the [CANCEL] button and proceed to step 10.
9 If you selected “2. Multiple Mode” in step 4, perform the following depending on the number of inserted cartridges.
Chapter 4 Operating the AIT Library | 52 |
|
|