Sun Microsystems 5602 manual Set Port Command

0	A – Command Line Interface
	Set Port Command

Set Port Command

Sets port state and speed for the specified port temporarily until the next switch reset or new configuration activation. This command also clears port counters.

Authority Admin session except for the Clear keyword.

Syntax set port [port_number] bypass [alpa] clear

enable

speed [transmission_speed] state [state]

Keywords [port_number]

Specifies the port. Ports are numbered beginning with 0.

bypass [alpa]

Sends a Loop Port Bypass (LPB) to a specific Arbitrated Loop Physical Address (ALPA) or to all ALPAs on the arbitrated loop. [alpa] can be a specific ALPA or the keyword ALL to choose all ALPAs.

clear

Clears the counters on the port. This keyword does not require an admin session.

enable

Sends a Loop Port Enable (LPE) to all ALPAs on the arbitrated loop.

speed [transmission_speed]

Specifies the transmission speed for the specified port. Choose one of the following port speed values:

1Gb/s

One gigabit per second. This applies only to ports 0–15.

2Gb/s

Two gigabits per second. This applies only to ports 0–15.

4Gb/s

Four gigabits per second. This applies only to ports 0–15.

10Gb/s

Ten gigabits per second. This applies only to ports 16–19.

Auto

The port speed is automatically detected. This applies only to ports 0–15.

59097-01 A A-79