Sun Microsystems 5602 manual Reset Command, Config configname

0	A – Command Line Interface
	Reset Command

Reset Command

	Resets the switch configuration parameters. If you omit the keyword, the default is
	Reset Switch.
Authority	Admin session
Syntax	reset
	config [config_name]
	factory
	port [port_number]
	radius
	security
	services
	snmp
	switch (default)
	system
	zoning
Keywords	config [config_name]
	Resets the configuration given by [config_name] to the factory default values for
	switch, port, port threshold alarm, and zoning configuration as described in
	Table A-9through Table A-12. If [config_name] does not exist on the switch, a
	configuration with that name will be created. If you omit [config_name], the active
	configuration is reset. You must activate the configuration for the changes to take
	effect. for switch, port, and port threshold alarm configuration default values.
	factory
	Resets switch configuration, port configuration, port threshold alarm configuration,
	zoning configuration, SNMP configuration, system configuration, security
	configuration, RADIUS configuration, switch services configuration, and zoning to
	the factory default values as described in Table A-9through Table A-17. The
	switch configuration is activated automatically.
	Note:	„ Because this keyword changes network parameters, the
		workstation could lose communication with the switch and
		release the Admin session.

„ This keyword does not affect installed license keys.

port [port_number]

Reinitializes the port given by [port_number]. Ports are numbered beginning with 0.

radius

Resets the RADIUS configuration to the default values as described in

Table A-14.

59097-01 A A-45