Explanation
(1)Number of labels to be issued
c If increment/decrement is not specified, the designated number of pieces with the same drawing data will be issued.
d If increment /decrement is specified, the designated number of pieces will be issued while incrementing/decrementing the piece of the designated drawing area.
*The increment/decrement designation is valid until the Image Buffer Clear Command ([ESC] C) is transmitted.
If no subsequent command is received from the PC for 1 second after issuing the last label, when automatic forward feed standby is set to “ON” in the system mode, the printer automatically performs a
When the Issue Command is received during the automatic forward feed standby, an issue is started after a reverse feed to the original position.
If any command is sent and processed after the Issue Command is sent, the automatic forward feed is not performed. Therefore, a command should not be sent after the Issue Command is sent. The power should not be turned off then on, or the printer should not be placed in a pause/reset state before the automatic forward feed, since the automatic forward feed is not performed when the paper is fed by turning the power off then on, or by pressing the [FEED] key of the printer in the pause/reset state.
If the paper is fed by pressing the [FEED] key of the printer during the forward feed standby, the printer feeds one label, performs the automatic forward feed, then stops.
(2)Cut interval
The cut interval is valid only when the cutter has been installed and the issue mode is “C”. If an error occurs during an issue after the cut interval is designated, and then printing is restarted, the printer ejects the printed paper, then resumes printing on the paper where the error occurred.
(3)Type of sensor
c No sensor: Printing takes place according to the parameter designated by the Label Size Set Command.
dLower reflective sensor:
Printing takes place according to the parameter designated by the Label Size Set Command. However, the black mark provided on the back of the tag paper is automatically sensed by the lower reflective sensor and the paper position is finely adjusted for every piece.
eTransmissive sensor (when using normal labels):
Printing takes place according to the parameter designated by the Label Size Set Command. However, the
fTransmissive sensor (when using preprinted labels):
Printing takes place according to the parameter designated by the Label Size Set Command. However, the
- 133 -
