5.2 LABEL ISSUE OPERATION
An example of the label issue operation is described below.
(1)Where the Saved Data Call Command is not used:
Power ON
|
|
|
|
|
| Place paper |
|
| |
|
|
| [ESC] D: Sets the label size. | |
Label Size Set Command | ||||
|
|
| [ESC] AX: Adjusts the feed length, cut position, | |
Position Fine Adjust Command | ||||
|
|
|
| and back feed length. |
|
|
|
| |
|
|
|
|
|
Print Density Fine Adjust Command
[ESC] AY: Adjusts the print density.
Feed Command
Image Buffer Clear Command
Line Format Command
Bit Map Font Format Command
Outline Font Format Command
Bar Code Format Command
Bit Map Font Data Command
Outline Font Data Command
Bar Code Data Command
Issue Command
Yes <Changed data issue>
YesNo <Format change>
Yes No <Label change>
No
Power OFF
[ESC] T: Feeds one sheet of paper and aligns it with the first printing position.
[ESC] C: Clears the image buffer.
[ESC] LC: Sets the line format and draws it.
[ESC] PC: Sets the bit map font format.
[ESC] PV: Sets the outline font format.
[ESC] XB: Sets the bar code format.
[ESC] RC: Draws bit map font data.
[ESC] RV: Draws outline font data.
[ESC] RB: Draws bar code data.
[ESC] XS: Issues (prints) the label.
NOTES: (1) When placing new paper, the Label Size Set Command and Feed Command must always be sent. When using the same paper after the power is turned off and on, the Label Size Set Command and Feed Command may be omitted.
(2)After the power is turned off and on, the Bit Map Font Format Command, the Outline Font Format Command, and the Bar Code Format Command should be sent as occasion demands because they are not protected in memory.
- 26 -
