First print position home position after back feed

[Fine Adjustment of Stop Position of Strip Issue]

0.0mm

+3.0 mm

-3.0 mm

4mm

3mm

2 mm

•Printing in the strip issue mode for the auto labeler stops at the position where the distance from the middle point of the label-to- label gap to the end of the strip shaft is 4 mm, since the label-to- label gap is assumed to be 2 mm.

•When the print stop position is not proper, the print stop position should be adjusted using the fine adjustment function of the stop position of the strip issue.

•When the label-to-label gap is 5 mm or more, the effective print length should be set to the maximum (label pitch -2 mm). Then, the print stop position should be adjusted using the fine adjustment function of the stop position of the strip issue.

[Back Feed Fine Adjustment] (To finely adjust the back feed for shifting backward or forward)

0.0 mm