Toshiba B-850 manual Stored PC command save file name

C: Stored PC command save file

SOH	STX	“C”	Slot	Stored PC command save file name	ETX	EOT	CR	LF
01H	02H	43H	xxH	File name 1 00H File name 2 00H ··· File name n 00H	03H	04H	0DH	0AH

Note

Slot:		File name (including extension):
		“00H” should be placed between file
“1” (31H):	Slot 1
		names.
“2” (32H):	Slot 2

In the following cases, 1 byte of “00H” is returned as the stored PC command save file name.

cThere is no file.

dThe ATA card is not inserted in the specified slot.

(2)This command is one of the types of commands that is processed as it is received. Processing takes place starting from the ones received first. Until the process of the command previously sent is completed, this command is not processed. Therefore, if the printer is not in the idle state when this command is sent, the data may not be returned immediately.

(1)This command is effective only for the serial interface (RS-232C).

This command is not supported for a parallel interface (Centronics), since transmission cannot be performed in the parallel interface.

- 185 -