Toshiba B-850 manual Reset Command ESC WR, Esc Wr Lf Nul

6.3.28 Reset Command [ESC] WR

Function

Format

Explanation

Notes

Example

Returns the printer to its initial state.

[ESC] WR [LF] [NUL]

The printer is returned to the same state as when the power is turned on. When the printer receives this command during printing, it returns to its initial state after issuing the label which is being printed. The next command must not be sent while the printer is performing initial processing (approximately 0.5 seconds) after this command is transmitted.

(1)The Reset Command is effective in serial interface (RS-232C) only. In parallel interface (Centronics), the reset request signal (nInit) should be used.

(2)When the printer receives a command in the system mode, only the Reset Command can be processed and any other command cannot be processed.

(3)If a command error or communication error occurs when receiving the Reset Command, the error message is displayed in the online mode. However, it is not displayed in the system mode.

(4)After the code of the Bit Map Writable Character Command ([ESC] XD) or Graphic Command ([ESC] SG) is received, the Reset Command is not processed until the printer receives the data specified for the type of data.

[ESC] WR [LF] [NUL]

- 181 -