Toshiba B-850 manual

(2)Storing PC interface commands

		Power ON
	No
			<New>
				Yes
(Add/change)

Memory Card Format Command

Save Start Command

Label Size Set Command

Position Fine Adjust Command

[ESC] J1: Formats the flash memory card. or

[ESC] JA: Formats the ATA card.

[ESC] XO, [ESC] XV: Declares the start of saving PC interface commands.

[ESC] D: Sets the label size.

[ESC] AX: Adjusts the feed length, cut position, and back feed length.

Print Density Fine Adjust Command

[ESC] AY: Adjusts the print density.

Image Buffer Clear Command

Line Format Command

Bit Map Font Format Command

Outline Font Format Command

Bar Code Format Command

Bit Map Font Data Command

Save Terminate Command

No Completion of

all storing

Yes

zStoring writable characters or logos

zLabel issue operation

[ESC] C: Clears the image buffer.

[ESC] LC: Sets the line format and draws it.

[ESC] PC: Sets the bit map font format.

[ESC] PV: Sets the outline font format.

[ESC] XB: Sets the bar code format.

[ESC] RC: Draws data of the bit map font.

[ESC] XP: Declares the termination of saving PC interface commands.

NOTES: (1) The storage of PC interface commands is only performed if it is required.

(2)When the flash memory card is used, and the Memory Card Format Command is not sent before storing already stored PC interface commands, memory will be taken up with every such storing.

(3)When the flash memory card is used, and another operation (storing writable characters or logos, label issue operation) is performed after storing PC interface commands, the image buffer will be cleared automatically.

(4)Select commands to be stored as the occasion demands.

(5)If another storing operation does not take place after storing PC interface commands, the printer enters the online mode (label issue operation) after about 10 seconds. In this case, when the flash memory card is used, the image buffer will be automatically cleared.

- 25 -