Toshiba B-850 manual Detail Status

9.1.3Detail Status

LCD Message

Printer Status

Detail Status

Auto Status	Status Request
Transmission	Command

ON LINE			The head was closed with the head open.		00	00
HEAD OPEN			The head was opened in the online mode.		01	01
ON LINE		****	Operating (Analyzing command, drawing,		–	02
			printing, or feeding)
PAUSE		****	In a pause state		–	04
Display of error message			A command error was found in analyzing the		06	06
			command.
COMMS ERROR			A parity error, overrun error, or framing error		07	07
			occurred during communication by RS-232C
PAPER JAM		****	A paper jam occurred during paper feed.		11	11
CUTTER ERROR****			An abnormal condition occurred at the cutter.		12	12
NO PAPER		****	The label has run out.		13	13
HEAD OPEN		****	An attempt was made to feed or issue with the		15	15
			head open. (except the [FEED] key)
HEAD ERROR		****	A broken dot error has occurred in the thermal		17	17
			head.
EXCESS HEAD TEMP			The thermal head temperature has become		18	18
			excessively high.
RIBBON ERROR****			An abnormal condition occurred in the sensor		21	21
			for determining the torque for the ribbon motor.
			The ribbon has run out.
ON LINE			The issue has been completed normally.		40	–
ON LINE			The feed has been completed normally.		41	–
SAVING	### &&&&		In writable character or		–	55
SAVING	%%%%%%%		PC command save mode
FLASH WRITE ERR.			An error has occurred in writing data		50	50
			into the flash memory card.
FORMAT ERROR			An erase error has occurred in		51	51
			formatting the flash memory card.
				Writable
FLASH CARD FULL					54	54
			Saving failed because of the	character,
			insufficient capacity of the flash	PC command,
				save mode
			memory card.
Display of error message			A command error has occurred in		06	06
(See Note 1.)			analyzing the command.
COMMS ERROR			A parity error, overrun error, or framing		07	07
			error has occurred during
			communication by RS-232C.

- 200 -