Using the SP Mode
SP command numbers can be entered directly (if you know the entire number) or the command can be selected from the menus.
Direct Entry
If you know all seven digits of the SP code, enter the seven numbers and press Enter key .
However, if you do not know all the numbers, enter only the first four numbers of the
Button Selection Entry
1.Refer to the SP Mode Tables at the end of this section to find the SP that you want to adjust.
2.Press the Group number on the left side SP Mode window that contains the SP that you want to adjust.
3.Use the scrolling buttons in the center of the SP mode window to display the SP number that you want to open, then, press that number to expand the list.
4.Use the center
5.To enter a setting
•Press key to enter a minus sign. Then use the keypad to enter the appropriate number. The number you enter will write over the previous setting.
•Press to enter the setting. (If you enter a number that is out of range, the key press is ignored.)
•Press Clear key to cancel the data.
6.If you need to perform a test print, press Copy Window to open the copy window and select the settings for the test print. Press Start C key.
7.Press SP Mode (highlighted) in the copy window to return to the SP mode display.
8.When you are finished, press Exit twice to return to the copy window.
B070/B071 | PTM |