
3.2 SERVICE PROGRAM MODE TABLES
NOTE: The Service Program Mode is for use only by customer engineers so that they can properly maintain product quality. If this mode is used by anyone other than a customer engineer for any reason, data might be deleted or settings might be changed. In such a case image quality can no longer be guaranteed.
Service Table Key
Notation | What it means |
[range / default / | |
step] | The default setting +3.0 can be adjusted in 0.1mm steps in the |
| range ±9. |
Italics | Comments added for reference. |
* | An asterisk marks the SP’s that are reset to their factory default |
| settings after an NVRAM reset. |
DFU | Denotes “Design or Factory Use”. Do not change this value. |
Japan only | The feature or item is for Japan only. Do not change this value. |
SEF | Short Edge Feed |
LEF | Long Edge Feed |
|
|
NOTE: The intent of this document is to not detail the Service Programs, please use the SM for that purpose.
3.2.1 COPIER SERVICE PROGRAM MODE TABLES
SP1-nnn Feed
SP |
| Number/Name | Function/[Setting] |
1001 | Leading Edge Registration | Adjusts the printing leading edge | |
|
|
| registration for feeding from the trays and |
|
|
| duplex tray using the trimming area |
|
|
| pattern |
|
|
| Use the “• / *key to enter the minus ( |
|
|
| before entering the value. |
|
|
| The specification is 4± 2 mm. ( |
| 001 | Copier/LCT Paper Tray | B070: |
|
|
| B071: |
| 002 | Duplex Tray | B070: |
|
|
| B071: |
| 003 | Copier//LCT Paper Tray (Low | B070: |
|
| Speed) | B071: |
| 004 | Duplex Tray (Low Speed) | |
1002 | Adjusts the printing | ||
|
|
| registration from the 1st paper feed |
|
|
| station using the trimming area pattern |
|
|
| |
|
|
| Use the “• / *key to enter the minus ( |
|
|
| before entering the value. |
|
|
| Specification: 0 ± 2.0 mm. ( |
| 001 | 1st Tray (Copier Tandem Tray) | |
| 002 | 2nd Tray (Copier) | |
| 003 | 3rd Tray (Copier) | |
| 004 | 4th Tray (LCT Tray 1) | |
B070/B071 | PTM |