Toshiba E-STUDIO900 manual Lower Tray Full

Lower Tray Full

[C]

[B]

[D]

[F]

[E][A]

[A]: Lower tray full sensor (sort/shift mode)

[B]: Lower tray lift motor

[C]: Lower tray encoder sensor

[D]: Encoder disk

[E]: Lower tray full sensor (saddle-stitch mode)

[F]: Lower tray paper sensor

The sensor that is used depends on which mode the user has selected.

Normal sorting/stapling, without saddle stitching: When the bottom of the tray actuates sensor [A], the lift motor [B] continues to rotate for a certain number of rotations. The rotations are detected using sensor [C] and encoder disk [D]. Then printing stops. If sensor [C] fails, the upper limit switch (lower tray) stops the motor. This switch (not shown in the diagram) is next to the plastic foam roller at the feed- out slot.

Saddle-stitch mode: Sensor [A] is not used. The tray is lowered until the actuator on the side of the tray actuates sensor [E]. Then printing stops.

In both modes, when the stack is removed from the tray, sensor [F] de-actuates and returns the lower tray to the initial position at the feed-out slot.

B070/B071 6-12 PTM