Toshiba MJ-1104, MJ-1103 Remove one clip and then remove the pulley and pin, Pin Pulley

(5)Remove one clip and then remove the pulley and pin.

Pin	Pulley
	Clip
Fig. 4-94

(6)Take off the spring. Remove one screw, and

then take off the paper holding unit

(7) Remove 2 screws, and then take off the fold- ing drive unit.

Note:

When installing, hang the 2 hooks of the fold- ing drive unit on the holes of frame.

Spring

Folding drive unit

Fig. 4-95

Note:

The gear bracket of the folding drive unit is installed to determine the positioning between the gears of the folding drive unit and the additional folding unit. Before taking off the units, mark the position on the scale of the frame where the mark of the bracket points so that you can install them at the same positions.

Scale Mark

Gear bracket

Fig. 4-96

MJ-1103/1104	© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION

4 - 34