Toshiba MJ-1104, MJ-1103 Remarks, Button1 Button2, B5 paper Vertical Adjustment sheet

(5)Press the [Button1] to adjust the alignment position.

Every time the [Button1] is pressed, the alignment plate shifts 1 step (0.419 mm/step) toward the “+ “direction. (The gap between the alignment plates becomes narrower.)

Adjustment range is from -5 to +5 steps.

If the [Button1] is pressed when the alignment position is at the “+5 step”, the plate will return to the home position and then moves to the position of “-5 step”.

LED3 LED2 LED1

Button1 Button2

Fig. 5-2

(6)Place the adjustment sheet on the process tray and adjust the position to make the gap between paper and the alignment plate “0”.

Then setting is performed at a value that is one smaller than the adjustment value.

	alignment plate
B5 paper	Vertical
Adjustment sheet	alignment roller
	Fig. 5-3

Remarks:

•Use an adjustment sheet made of plastic resin which is light and accurate in measurement (e.g. OHP film).

•To reduce frictional resistance with the vertical alignment roller on the process tray, place a sheet of B5 paper beneath the adjustment sheet on the vertical alignment roller.

•Confirm the gap between paper and the alignment plate by moving the adjustment sheet for- ward and backward to reduce affect by backrush of the gear of the side alignment plate.

MJ-1103/1104	© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENTS

5 - 2