Toshiba MJ-1103, MJ-1104 service manual Take off the belt from the stack transport motor, Belt

(4)Take off the belt from the stack transport motor.

Belt

Stack transport motor

Fig. 4-273

4

(5)Remove 3 screws, and then disconnect each connector of the finishing tray paper detec- tion sensor and the stack exit belt home posi- tion sensor and the relay connector of the paper exit guide clutch. Then take off the stack exit belt unit.

Notes:

•Be sure not to lose the belt.

•When installing the stack transport belt unit, attach the rotation protection of the paper exit guide clutch.

(6)Remove 1 screw, and then take off the sen- sor bracket.

Note:

When taking off the sensor bracket, the actu- ator and the spring are also taken off. Be sure not to lose the actuator and the spring.

rotation	Stack exit belt unit
protection
	Paper exit
	guide clutch
	Fig. 4-274

Sensor bracket

Fig. 4-275

© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved	MJ-1103/1104
	DISASSEMBLY AND INSTALLATION

4 - 97