Toshiba MJ-1103 Units Saddle section MJ-1104, Saddle unit, SDL board, Table beneath, Support

4.3Units (Saddle section: MJ-1104)

[A] Saddle unit

(1)Take off the front lower cover.

 P.4-4 "[E] Front cover / Front upper cover / Front lower cover"

(2)Remove 3 screws, and then take off the SDL board cover.

(3)Release the harness out of 3 clamps, and then disconnect each connector of CN10 and CN13 on the SDL board.

(4)Place a table beneath the pulled-out saddle unit to steady it.

Note:

Store (flip up) the saddle unit support before placing a table beneath the unit.

(5)Remove 8 screws and store the right and left rails.

SDL board cover

Fig. 4-71

SDL board

Clamp

Fig. 4-72

Table beneath

Saddle unit

support

Fig. 4-73

MJ-1103/1104	© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION

4 - 26