Toshiba MJ-1103, MJ-1104 service manual Junction Box, Junction box paper detection sensor

3.1.2Junction Box

Paper transported from the connected device is then detected by the feeding sensor (S22) and caught with the feeding roller. Then it is transported to the Finisher section or the saddle stitch section after the transport path switching solenoid (SOL5) switches its transport path with a flapper.

When it is transported to the Finisher section, the flapper does not move but the entrance roller trans- ports it to the Finisher section.

When it is transported to the saddle stitch section, the transport path switching solenoid (SOL5) is turned ON to switch the transport path with the flapper. The paper is then transported to the saddle stitch section with the junction roller. The junction box paper detection sensor (S26) detects the passing of the paper.

The feeding roller and the junction roller are driven by the entrance motor (M1) of the Finisher section.

Transport path switching solenoid

Flapper

Entrance roller

Entrance motor

Feeding roller

Feeding sensor

Junction roller

Junction box paper detection sensor

Fig. 3-4

3

© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved	MJ-1103/1104
	DESCRIPTION OF OPERATIONS

3 - 3