Toshiba MJ-1104, MJ-1103 service manual Upper exit roller / Upper exit roller guide

[I]Upper exit roller / Upper exit roller guide

(1)Take off the rear upper cover.

P.4-6 "[G] Rear cover"

(2)Take off the control panel unit.

P.4-3 "[D] Control panel unit"

(3)Remove 2 screws, and then take off the front and rear stays and 2 spacers.

Note:

Be careful not to damage the harness con- nected to the stationary tray transport guides.

(4)Loosen 2 screws each for the front and rear stationary tray discharge brush.

(5)Remove 4 screws and take off the front and rear stationary tray transport guides.

Note:

Be careful not to damage the harness of entrance sensor.

Spacer	Stay
Stay	Spacer
	Fig. 4-156

Stationary tray transport guide

Stationary tray

discharge brush

Fig. 4-157

Note:
When installing the front and rear stationary	Stationary tray
tray transport guides, fix them at the posi-
	transport guide
tions where the gap between the trailing
edges of the guides and the frame is 1 mm.
Check if the flap and the upper exit roller
move smoothly after screws are tightened.
	1mm
	Fig. 4-158

MJ-1103/1104	© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION

4 - 56