Toshiba MJ-1103, MJ-1104 service manual LED3 LED2

(5)Press [Button 1] to adjust the stapling position.

Every time [Button 1] is pressed, the alignment plate shifts 4 steps (0.45 mm) toward the "+" direction. (It moves toward the rear side.)

Adjustment range is from -20 to +20 steps. If [Button 1] is pressed when the alignment position is at the “+20 steps”, the plate will return to the home position and then moves to the position of “- 20 steps”.

Note:

Stapling for checking the position can be done by pressing [Button 2] with sheets placed on the finishing tray. (stapled on the rear side)

LED3 LED2 LED1

5

Button1 Button2

Fig. 5-5

(6)When the adjustment is completed, press [Button 2] on the finisher control panel to store the adjustment value in memory without sheets on the finishing tray.

When the value is stored normally, [LED 1] on the control panel will blink for a number of times that corresponds to the adjustment value set for the equipment.

See the following table for the number of times [LED 1] blinks and its corresponding adjustment value.

Number of blinking	Adjustment value
1	-20
2	-16
3	-12
4	-8
5	-4
6	0
7	+4
8	+8
9	+12
10	+16
11	+20

(7)Turn OFF the power of the equipment.

(8)Turn OFF all bits of the SW1 on the Finisher control board.

(9)Install the board access cover.

© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved	MJ-1103/1104
	ADJUSTMENTS

5 - 5