Toshiba MJ-1104, MJ-1103 service manual Stapling/folding position adjustment in saddle unit, Sample

5.3Stapling/folding position adjustment in saddle unit

Perform this adjustment when the saddle control PC board was replaced or the stapling/folding position must be changed for some reason.

Prepare 2 types of booklet samples using the main unit and use them for adjustment accordingly.

(1)Create 2 types of booklet samples (1 set each) using the main unit.

	Sample 1	Sample 2
Media type	Recomended paper	Recomended paper
Paper size	A4	A3
Number of sheets	5 sheets	5 sheets

(2)Measure the stapling and folding positions of the samples, and then perform adjustment accord- ingly.

For stapling and folding, paper on the stacker of the stacker unit is moved to an exclusive mech- anism for stapling or folding. Therefore adjustment must be performed individually for the folding stopping position of the stacker and the stapling stopping position.

*Check the folding position at the centerfold page of the sample.

Paper exit direction

Center

fold

page

-2mm - +2mm

-2mm - +2mm

Fig. 5-6

*Check the stapling position at the centerfold page of the sample.

When the staples are bent

Staple

Do not include the

width of the staples

-0.5mm - +0.5mm

Staple

-0.5mm - +0.5mm

Folding line Folding line

Fig. 5-7

MJ-1103/1104	© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENTS

5 - 6