Toshiba MJ-1103 service manual Paper holding clutch CLT4 MJ-1104, Catching solenoid SOL1

(3)Take off the gear bracket. Disconnect the relay connector, and then take off the1 bear- ing and folding blade clutch.

Note:

When installing the folding blade clutch, attach a rotation protection.

Bearing

Folding blade

clutch

Gear bracket

Fig. 4-228

4

[D] Paper holding clutch (CLT4) (MJ-1104)

(1)Open the front upper cover and then pull out the saddle unit.

(2)Disconnect the relay connector, and then release the harness from the clamp.

(3)Remove 1 E-ring , and then take off the paper holding clutch.

Note:

When installing the paper holding clutch, attach a rotation protection.

Paper holding clutch

Fig. 4-229

[E]Catching solenoid (SOL1)

(1)Take off the junction box unit.

 P.4-13 "[A] Junction box unit"	FIN board
(2) Disconnect the connector of the CN23 on the
FIN board, and then release the harness out
of 4 clamps.

Clamp

Fig. 4-230

© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved	MJ-1103/1104
	DISASSEMBLY AND INSTALLATION

4 - 81